
Oak plank headboard wall with floating nightstands
A wall-to-wall headboard of wide oiled oak planks with shadow gaps, on furring battens into the studs and a pine sole plate faced in oak, capped by a ledge for a glass of water and a book. Two oak nightstands with a drawer each hang on French cleats either side of the bed, so the floor under them stays clear for slippers and the vacuum, and two black swing-arm lights are screwed to the planks above them.
Passes Crava's checks for fit, strength and stability. Change any size, the wood or the finish in the app, and it is checked again.
At a glance
- Overall W x D x H
- 2940 x 430 x 1230 mm115 3/4" x 16 15/16" x 48 7/16"
- Parts to cut
- 43
- Build steps
- 38
- Boards
- 17
- Sheets
- 3
- Solid wood
- 48.8 bd ft
- Weight
- 110.6 kg244 lb
Materials
- White oak
- Birch plywood
- Pine (eastern white)
Finish
- Finishing oil - Hardwax oil, matt
Tools
- Saw
- Square
- Tape
- Router
- Drill
- Table saw
- Clamps
- Sandpaper
- Brush
- 10mm bit
- Cable clips
Hardware and fittings
- 2 x Anti-tip furniture wall bracket, steel, with stud screws
- 4 x Side-mount drawer slide, 300mm
- 2 x Edge pull, 150mm, matt black
- 2 x Plug-in swing-arm reading light, matt black
Cut list
The first 3 of 22 lines, in millimetres (inches below), finished size including joint allowances.
| Letter | Qty | Part | L x W x T | Material |
|---|---|---|---|---|
| A | 2 | French cleat, wall half | 430 x 80 x 1816 15/16" x 3 1/8" x 11/16" | Birch plywood |
| B | 2 | Night left - Drawer 1 box | 396.5 x 140 x 1215 5/8" x 5 1/2" x 1/2" | Birch plywood |
| C | 1 | Night left - Drawer 1 bottom | 396.5 x 288 x 615 5/8" x 11 5/16" x 1/4" | Birch plywood |
| +38 more parts | ||||
Open this design in Crava to see the full cut list and plans - all 43 parts, cutting diagrams for every board and sheet, a drawing of each part, and the 38 build steps in order.
Open in CravaOpening and changing a design needs no account. The full plans come with a free one.
The 3D model
